diff --git a/Getting_Started.md b/Getting_Started.md index ff592f8b..bb40c70e 100644 --- a/Getting_Started.md +++ b/Getting_Started.md @@ -178,6 +178,16 @@ CE D2 (GPIO4) IRQ D0 (GPIO16 - no IRQ!) ``` +ATTENTION: From development version 108 onwards, also MISO, MOSI and SCLK +are configurable. Their defaults are correct for 'standard' ESP32 boards +and non-settable for ESP8266 (as this chip cannot move them elsewhere). +If you have an existing install though, you might see '0' in the web GUI. + +Set MISO=19, MOSI=23, SCLK=18 in GUI and save for existing installs, this is the old +correct default for most ESP32 boards, for ESP82xx, a simple settings save should suffice. +Reboot afterwards. + + ## Flash the Firmware on your Ahoy DTU Hardware Once your Hardware is ready to run, you need to flash the Ahoy DTU Firmware to your Board. diff --git a/src/CHANGES.md b/src/CHANGES.md index dff8eb2a..c53c6875 100644 --- a/src/CHANGES.md +++ b/src/CHANGES.md @@ -11,7 +11,8 @@ * ePaper: centered text thx @knickohr ## 0.5.108 -* merge: PR SPI pins configureable (ESP32) #807, #806 + +* merge: PR SPI pins configureable (ESP32) #807, #806 (requires manual set of MISO=19, MOSI=23, SCLK=18 in GUI for existing installs) * merge: PR MI serial outputs #809 * fix: no MQTT `total` sensor for autodiscover if only one inverter was found #805 * fix: MQTT `total` renamed to `device_name` + `_TOTOL` for better visibility #805